position alignment
I was wondering if the position alignment for the 72" array can be used with the 48" array . I believe that it stops the array in the same position each time the unit is shut down but i'm not sure ....
View ArticleDragonfly 7 - New installation
I just get a new dragonfly7 , ( version E70231 gold ) 1- I got tne navionics map with the sonar but the capacity of the SD card included is only 4 GB, will it be enough to keep datas ? ( If datas are...
View ArticleHummingbird 1199 CI/SI Display
Hello, I'm wondering about tying in my Hummingbird display into my EV-100 Autopilot with a p70r control ? I searched for Hummingbird but nothing came up? Is there a adapter cable to do this if so would...
View ArticleReplace E120 Classic with ES127 MFD Cutout
I'm planning an electronics upgrade. I currently have a e120 classic flush mounted in the helm. I want to replace it with an eS127. How does the cutout for the two MFDs differ? I hope I can fit the new...
View ArticleRay70 RayMic
Hello! I just installed a Ray70, and all is good! My question, is it possible to power on the Ray70 from either a MFD (E7D) or the RayMic? In my setup, it's possible the Base Station could be not...
View ArticleAIS 250
I have a Raymarine 250 AIS networked with a E95 on my sailboat. I'm able to identify targets but often the boat name is missing, I only see MMSI number. For example, at the moment, I can see 24 targets...
View Articlee7 User Settings
I have noticed that my e7 MFD (sw v16) does not seem to save certain settings. Such as, if I hide all routes, waypoints and tracks, when power cycled they all are shown again. Another is the...
View Articleradar compatibility
I purchased an a98 mfd to replace a classic C80 which stopped functioning. I have a Pathfinder 2d ray dome, (AM92650-S0360774) which had been used with my C80. I have been looking at the Quantum Radar...
View ArticleEffects of adding Sonar Charts and/or Community Edits to a NAV+ chart card
When initially introduced by Navionics, the NAV+ chart cards were not populated with cartography and required that their owners register the chart card via the Navionics web site and then use the...
View ArticleClik here to view.
a/c/e/eS/gS-Series MFD updated w/v16.47 unable to update remote devices
The a/c/e/eS/gS-Series MFDs which have been updated with v16.47 a/c/e/eS/gS-Series MFD software require a different set of autorun files to remotely update other Raymarine products than did...
View ArticleNew Sirius Raymarine 150 Receiver
I recently purchased a ES Series multifunction display and had to upgrade the Sirius received to the 150. O have weatehr and music subscription with Sirius. I can hear the music, but can only see the...
View ArticleAuto Pilot Replacement
I currently have an ST7000 Autohelm that has started to fail. I say started, the 5A fuse controlling the ST network ports blew on the CCU and when it did it caused one of the two ST ports to fail. I...
View Articlest8001 encoder
What are the specs on the st8001 encoder? I want to get a replacement encoder since parts are not available.
View ArticleES128 to/from VHF DSC via NMEA
I would like to verify the connection of a ES128 MFD to a Icom M412 VIA NMEA wiring. It is connected as follows: Icom MFD NMEA in - (shield) to Brown output - NMEA in +(red) to Yellow output + NMEA...
View Articlee125 - VHF DSC Intergration via Seatalk
Hi, I am trying to integrate my new Standard Horizon Matrix GX2000 with my e125 MFD. The Chartplotter is at the helm station and is linked to my existing Seatalk 1 network via a seatalk to seatalk ng...
View Articleno rudder
my st7001+ pilot can not understand correct rudder position can i use this autopilot without the rudder position
View ArticleBest depth transducer for eS127?
We just bought new Raymarine instrument packages (eS127, charts, EV400 autopilot, AIS), and hoped we'd be able to re-use our Raymarine inside-the-hull transducer, but it only has 4 pins (from a...
View ArticleEC100 compatable with Cummins Diesels
I just purchased a new c125 to go along with my classic c120. I elected to keep the classic 120 as all of the radar and auto pilot functions are accessed through it. I noticed that the new display has...
View ArticleST60 repair
I have two ST60 Graphic Displays and a ST60 Maxview Display in need of repair. It looks like the Maxview screen burned out and then that took down the two Graphic displays that were networked to it. Do...
View Article