Quantcast
Channel: Raymarine forum - All Forums
Viewing all 8621 articles
Browse latest View live

I70 Fast Beeping

$
0
0
This past week I assisted a friend relocate his new (to him) 2016 Formula PC40. The boat is equipped with an e127, AIS700 (new, added before delivery), p70, i70, SeaTalk to STNG converter, EV-2, RS130 GPS. Radar All software is at or close to current levels.

I believe that this is a voltage issue but would appreciate your input.

During our trip, the i70 had a fast beep that we could not silence. There was no ALARM indicated. We went in and disabled all the alarms via the i70 menus, to no avail. We eventually shut it off.

When we reached our new location, shut down the engines and tried the i70. Fast beeping started immediately; shut it down. All alarms remained disabled via the i70 menu.

Next day, tried it again with slightly different results. Upon power up, fast beeping for about 4 seconds, then the system shut down by itself. I then held the power button on for approx. 5 seconds. The fast beeping started right away and white screen with "Battery" displayed in the upper left corner, "volts" in the upper right corner and 3 black rectangles displayed in the middle of the screen.

Pressed the i70 menu button and the menu came up. Went thru the screens but could not find any indication of the problem.

Went to the p70 and went thru its menus and found that it indicated a tempo of 32.91 C and Volts 10.28. Good indication of a power issue.

Went to the e127 and looked at the various network info. All devices were found, but the voltage for the e127 indicated 9.4 volts. Power is probably an issue.

So there appears to be a real issue with power. Just want to verify that it is causing the fast beeping on the i70. He is going to have the charger and batteries looked at.

As always, sorry for the book. I do have software version numbers if needed, but did not feel they added any useful info at this point.

Thanks in advance.

Steve.

Axion/e127 data compatability

$
0
0
My boat has an Axiom Pro 9 and Axion 9, networked with a Quantum 2, AIS 700, Ray 60 VHF, P70/EV-1 Auto pilot, etc. The MFDs are current (3.11.42)

My friend has a new (to him) 2016 Formula PC40 with an e127, p70, i70, EV-2, radar, AIS 700, etc. His MFD is at v19.03-00036 (Light House 2).

We both are using Navionics Platinum charts.

I would like to export my routes and waypoints and import it onto his system. I thought I read a post last year that mentioned that here were some restrictions (e.g. name length), but I could not find it.

Is this export/import possible and what are the restrictions, if any.

Thank you for your assistance.

Steve.

STV45 Wifi

$
0
0
Does this unit have WiFI?
I Downloaded the APTUS app but cannot seem to conntect to the unit via wifi as discussed in the instructions. I just got this 2006 boat and it came with this unit installed. I want to verify I have the latest software .

45STV Gen 1 or 2

$
0
0
How do I tell the difference? What more does Gen 2 offer? Is it just the controller or is it the dish unit also?

MIM upgrade for STV37

$
0
0
Hi,
Is there a MIM upgrade for the Raymarine STV systems to use the Wally receiver? I know Intellian has this MIM upgrade to allow for the auto switching function to work properly. If not, Is the Raymarine MIM and the intellian MIM the same MIM just rebranded?
Thanks

[TG11] GPS data source selection "internal" or "internal (active)"

$
0
0
I have recently completed a software upgrade on all the components of my system (see attached). It appears that the data source selection for GPS position and datum was is set to "Auto" after the software upgrade and I am unsure what this was set to prior to the upgrade.

In the case of GPS position and datum (and maybe time/date) the available choices for data source are "Auto", "0320444 internal", and "0320444 internal (active)". The latter two choices are the master MFD but seeing they are both the same should I be selecting the "active" one from the list or does it not matter? Why is this duplicated in the list?

Thanks,

tmass60

.jpg  20200509_201444.jpg (Size: 303.38 KB / Downloads: 3)

.jpg  20200509_201510.jpg (Size: 306.8 KB / Downloads: 2)

[TG11] Replacing T120 masthead transducer

$
0
0
I need to replace my T120, which lost its cups due to bird damage. How do I get the system to pair with the new unit? The old unit is still at the top of the mast, and the new unit in the cabin awaiting pairing.

[JB] R41 Display Help

$
0
0
I have a raytheon R41 raster scan radar from approx 1988. The monitor quit an d I was wondering if anyone know which other (if any) monitors would be compatible as I am having a hard time locating the R41 monitor. Can anyone provide a list of compatible monitors?
Thanks!

[TG11] AIS data on SeaTalkNG Network

$
0
0
I am trying to get AIS to show up on my e95 Chartplotter through the Seatalk-ng network. I have run the AIS output of my Standard Horizon GX2150 to the high speed input of a Noland multiplexer and the high speed output of the Noland to an Actisense NGW-1 converter. That runs into the Seatalk network, but I don't see any AIS targets on the e95 even when the GX2150 shows targets nearby. Any suggestions as to why this is not working? Thanks- Dave

[JB] What gauge is the wind transducer wire

$
0
0
I have an analog masthead wind transducer cable that I need to splice. I will get the marine grade male and female plugs but have two questions:

1. How many wires are in the cable (I have read 5 but only see 4)
2. What gauge is the wire?

Thanks!

Barry

[TG11] 3.11.42 update and no heading error

$
0
0
I just upgraded my Axiom Pro to LH 3.11.42 and now I keep getting an error message saying “no heading” despite my mfd showing a heading from my autopilot. I’m not sure if the LH upgrade was the culprit or it’s just a coincidence. Any ideas to fix this error?

passive speaker bezel removal for ray90 VHF

$
0
0
I have a ray 90 with a passive speaker which is screwed on to a wooden panel.
The screws are behind the bezel on the speaker. I need to take the speaker off to get work done on the panel. How do you remove the bezel so that no damage is done to the bezel or the wood.

Thanks
Tom

[TG11] Sonar Addition to Es7 Configuration

$
0
0
I have a 44ft cruising catamaran we are sailing around the world. Boat is currently in Tonga. I want to add sonar capabilities to my current equipment profile (Es-127 & Es-97; DST-800; Itc-5)

Questions are:
Q1: Do I need any additional equipment to enable Sonar? If so, options and recommendations?
Q2: Does B744V work in the current DST-800 thru-hull / sleeve?
Q3: Can the current DST-800 wiring be used for the B744V? Or is a new wiring run required?
Q4: Pro’s and Con’s of using the B258. Understand a new thru-hull and wire run is required as the DST-800 can’t be replaced.
Q5: Would like to confirm the B260 is not compatible with my current equipment profile.
Q6: Do you have sample wiring diagrams for the recommend sonar equipment and my current setup?

Thanks
Jeff

[JB] Next Lighthouse 3 Update

$
0
0
Hi Raymarine:

Are you still planning to update Lighthouse 3? The last update was November - 6 months ago. Prior to that there were updates every 2 months or so - even more frequent during the summer season.

Regards,
Keith

[TG11] Displaying heel angle data from EV Sensor

$
0
0
I have EV-1 Sensor and ACU-200 and an Axiom Pro MFD on my sailboat. I believe that the EV-1 measures heel angle. Does the autopilot put heel angle data on the SeaTalkNG bus? And if so, how do I display heel angle on the MFD?

If heel angle data is not on the bus, nor displayable, then I request that this feature be added. Knowing heel angle on a sailboat can be useful to optimizing performance, reefing, etc. (Obviously a marine clinometer would give you this information. But that is so 1800's :-)

Regards,
Mic

[JB] Rearrange Axiom Apps

$
0
0
Fairly new to the Axiom MFD and struggling with what should be a simple issue. Previous owner had customized a number of app combos (chart/radar, chart/fishfinder, fish finder/radar, etc.). I have deleted some of his customized apps and inserted some of my own but I'm left with blank spaces on page 1 and 2. Can't figure out how to rearrange the apps and get rid of the blank spaces. HELP!!!
Jim

[TG11] Reading the bottom

$
0
0
hi everyone. Have purchased Dragonfly Pro 7. Trying to interpret the bottom in sonar mode. Am I correct that if in standard color plate that red is hard bottom and that the thinner the red line the harder the bottom is and if its thicker red then it is somewhat softer as the sonar penetrates further. I believe that if there are lighter color bands on top of red that means mud or weed ?

Thanks

[TG11] 6001 holds then goes off course

$
0
0
When I engage auto to hold course it works for 10 minutes or longer and then goes off course and I can’t get it to hold in auto usually for the rest of trip. Sometimes it’ll say no data but most often just shows the course I was on but goes off course

[JB] Help Identify Equipment

$
0
0
Hi every one: trying to identify what type of equipment, is on a recently purchased boat. Sea Ray Amberjack 2005 it is equipped with Raymarine VHF radio and all in one chart plotter fish finder. Is there any way to get a model#, and download user manual ?

E80 - how did I tell what GPS I have?

$
0
0
Hello,

I have an E80 with verision 5.69. My Formula 34 PC has the GPS on the radar arch and I looked at it last night. There are no markings on the unit. How do I tell what GPS it is? I am having a long time for the GPS fix to connect and believe it is the battery, but want to know if I have to solder it or just replace it.

Thanks, Rob
Viewing all 8621 articles
Browse latest View live


<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>