AIS 650
I know there is a gps antenna delivered with the AIS650, but I have an antenna Raystar 120 already installed that are not in use but installed on the boat, is it possible to use this antenna instead?
View ArticleNMEA position data from Course computer S1G
I have a MFD e7, course computer S1G and Raytheon ST60 instruments, ST60 multi and ST6002+ All system is converted to Seatalkng with use of the ng converter. I need to have a NMEA output to get...
View ArticleI can no longer access my list of registered products
I can no longer access my list of registered products The primary purpose of Raymarine's product registration web pages has always been and continues to be for gathering data concerning Raymarine...
View Articledepth finder compatability
Hi Chuck Hoping you can help me out. I have a new i40 depth instrument and I bought a new, old stock transducer (airmar B16, also has a tag saying Raytheon 10008 with many more numbers) from ebay....
View ArticleCalibrating the autopilot
Hi Chuck! I have a 32 footer sailboat with a wheel rudder. I have a complete Evolution Autopilot system with ACU100 (wheel) and p70 control head, but without rudder reference trasducer. I have done the...
View ArticleAIS 650 ANTENNA INSTALLATION
I have a C 125 chart plotter and will add an AIS 650, and a dedicated VHF antenna, there is any problem or interferences between VHF radio antenna and the one from the aIS close ? tthere is any...
View ArticleDragonfly 6 with CPT-60 issues
I have had the Dragonfly 6 on my boat since 2015 and have intermittent issues. The GPS takes a long time (>5 minutes) to acquire a lock and occasionally loses location lock while underway. My boat...
View ArticleEV200 will not disengage
hwy1cat36 Wrote: Hello, I purchased a ev200 linear autopilot and early on it would not disengage right away and would take about 30 seconds. Now it will not disengage at all. I read some information...
View ArticleVoyage Planner Charts
I am somewhat of a newbie to Raymarine products. So I have a e97 MFD and fish out of Destin Florida out into the Gulf of Mexico. I have been very successful loading GPX waypoints. But the background...
View ArticleClik here to view.
Interfacing a Raymarine product's NMEA 0183 port to more than one device
Interfacing a Raymarine product's NMEA 0183 port to more than one device The 4800 BAUD NMEA 0183 output of Raymarine products may be paralleled to supply data to up to three 4800 BAUD NMEA 0183...
View ArticleST60 Wind Problem
I have a ST60 wind instrument. We were in the States for the summer and on returning to Jamaica four month later the wind direction works fine but the speed stays at zero even in about 30knots. After...
View ArticleST series
What ST series would you recommend for a 35 powerboat weighing 20K lbs. I have a E120 MFD.
View ArticleUpgrade RS120
I have a L760+ and ST6001+ connected to one of the Seatalk ports on my 400G Course Computer. The other Seatalk port has a RL80c+, ST6002, RS120 and RF base for wireless remote. My RS120 has started...
View Articlee7 Cycles on and off
My e7 has been working fine, but yesterday it started cycling. It starts, loads the chart, gets the GPS fix as usual, but then turns off. It then restarts by itself and goes through the same loop,...
View ArticleRaymarine devices and nmea2k and nmea0183 newtork.
I have an a78 Display with CHIRP/RD418D Digital Radome, Non-WiFi. With the radar, and sonar I have used all the ports on the back of the a78. I also have a NMEA2k network on the boat, that connects a...
View ArticleAutopilot control head and course computer
I have a Luhrs Tournament 400 and the Cetrek autopilot needs replacing. All the other electronics are Raymarine, E90W, C70 and DS600x so I am going the used Raymarine route. Can anyone advise in simple...
View Articlee7 stuck in initialization mode?
I have an e7 with Lighthouse 17. The unit is displaying the following: ============================ Raymarine Initialization <WPT> Reset to factory defaults <BACK> Exit and start the...
View ArticleDifferences between ST6002 and ST6000+ display
Hi, I have a ST6002 display that came with a SPX-5 AP. I have connected a ST6000+ display to use as a repeater. I have also upgraded to an SPX-30. Can you tell me the differences between the ST6002 and...
View ArticleAdding a C95MFD to Garmin GNX20 Instruments
I recently purchased a 35ft C & C that has pretty new (less than one year old) Garmin GNX Instruments and transducers. I would like to add a C95 MDF and a P70 Auto Pilot. I'm pretty new to this so...
View ArticleSoftware updating
I have recently acquired a 2013 e127, ACU200, DSM300,p70R, & a 4kx HD 18" Radome. The software has never been updated. Following the Raymarine instructions (I think), I uploaded a massive list of...
View Article