Fuel Used Problem
I currently have two E127s interfaced with my Yamaha SHO 250 and receiving engine data properly. I set the fuel tank size at 50 gallon and am getting, it appears a proper fuel flow reading but when the...
View Articletwo versions of A67 MFD wi-fi
I cannot find the wi-fi settings on my A87. Are there two versions of the A67 ? One with and one without wi-fi ?
View ArticleSmart auto helm controller battery is dead...
My smart controller battery is not holding charge. Product code is : A18105 CE 0191 IC: 4069B-SMART I took the battery out, it is a Varta 2/ VH 1600. 2.4V 1600mAh Where and how fast can I get this part...
View ArticleClik here to view.
importing .gpx to MFD
I am trying to load waypoints onto my ES128. There are approx 3000 of them. They are in 2 files. The MFD only takes about 90 of them then errors "card in use retrieving failed". How do I load them?...
View ArticleRadio Connector
I've had two Raymarine radios in my SeaRay boat. The OEM radio was a DSC 215. The replacement was a DSC53. Both had a female connector on the wiring harness that pugged directly into my boat. Are these...
View ArticleRadar Power Connection
I have not been able to power my radar on. I have a brand new cable and I get 0 Ohms when reading between the + (red) and ground (green). When I measure between + (red) and -(black) I get infinite....
View ArticleInterfacing an E-Series Classic MFD to a Raymarine Digital/HD/SuperHD Digital...
Raymarine's E-Series Classic MFDs were initially designed to be compatible with radomes and open array pedestals featuring an analog video interface. Later, Raymarine added support for radomes...
View Articleantenna/gps proximity to Radar
I would like to mount the AIS 650 antenna & gps on the 10' mast where the radar is mounted. are there vertical / horizontal separation requirements. Thanks Les
View ArticleConnecting SeaTalk1 and NMEA2000 using the SeaTalk Converter
I am installing a NMEA2000 network (using Maretron cables and connectors) and would like to connect it with my SeaTalk1 network. My SeaTalk1 network connects several ST60+ instrument displays and an...
View ArticleScanner will not start without help at beginning of season
I have an RL 70 pathfinder radar (18"). For two years in a row when I have connected the mfd the scanner was not detected. After going up the mast and giving it a spin it began to work fine. The motor...
View ArticleClik here to view.
Raymarine C80
Good day all, I have attached some pics of the junction where my gps, antenna and I believe transducer meet. Went to use this boat the other day and had no GPS this is what I found. Would appreciate it...
View ArticleReplace e120W to e127 Chartplotter
Hello, I would like to replace my e120W Raymarine Chartplotter with the e127. Installed is a Raymarine SR6 Sirius Receiver Network Switch. I have a ST70 that just displays Depth, Speed. Could you...
View ArticleNew Navionics Platinum+ on Classic E-80
I just purchased a new Navionics + card and updated it on line with their guidance at their site and tried loading it on my Classic E-80 and it caused the E-80 to freeze. I could not even operate the...
View ArticleHD Radar installation questions
I have a 28' walk-around fishing boat with a hard top. I recently installed an A98 MFD and EV 100 Autopilot. It has an old radar unit mounted so I was going to install a Quantum so I wouldn't have to...
View ArticleNetworked es127 MFDs not Sharing Data
Just installed a Quantum Radar and two es127 displays connected via SeatalkNG backbone per Reference Manual 81300-1, but the displays are not sharing charts, sonar, or radar data. Updated both MFDs to...
View ArticleRAY60 with v1.28
I have a RAY60 with v1.28 (upgraded over the internet) - but I'm confused, I do not see v1.28 anywhere. I have a 2nd station that is new out of box with VH1.01 on it. When I turn on the 2nd station - I...
View ArticleSmart Controller and Base Station/Seatalk ng
I just did a complete refit with new Seatalk ng instruments, Evolution AP, sG MFD etc. The old intrumentation died due to a lightning strike. My client would like to keep his Smart Controller and Base...
View ArticleMarpa and a Fast Heading Sensor
I have an eS MFD and the new Quantum Radar. Networked to them I have sailing instruments and an AIS. Do I need a Fast Heading Sensor in order to get Marpa? My AP is an old Simrad unit and is not...
View Articledst800 installation
I am planning to replace an old Data Marine system with RayMarine. The package purchased for installation includes a DST 800 Tridata transducer. If I mount the DST 800 transducer "flush" will the...
View ArticleC120 - Fishfinder Setup missing from menu
I have a C120 and my fishfinder's temperature is reading a few degrees high. After consulting the manual, I see that can be adjusted via Menu -> Fishfinder Setup. However, when I select my Menu,...
View Article