I have recently purchased an EVO 100 wheel pilot (sail) and am just finishing the install. The wheel pilot needs to be connected to an existing B&G Triton instrument package (speed / depth / wind). The B&G system has a "nema 2000" backbone cable.
Questions are as follows;
1) Do the Raymarine / nema 2000 and the B&G nema 2000 backbone cables have to be connected "end to end" or can the Raymarine backbone be connected to any "T" connector in the existing B&G backbone.
2) What is the Raymarine adapter cable required to connect the 2 backbone cables? Is it one of the following AO6045, AO6075, AO6076 or AO6046 dependent on length and gender of the end connectors?
3) I assume that the Raymarine backbone will not require a 12 volt feed as the B&G backbone is already powered. Is this correct?
4) Anything else that I need to be aware of?
Bob Hickson
C&C 29 mk 2
bobhickson@rogers.com
Questions are as follows;
1) Do the Raymarine / nema 2000 and the B&G nema 2000 backbone cables have to be connected "end to end" or can the Raymarine backbone be connected to any "T" connector in the existing B&G backbone.
2) What is the Raymarine adapter cable required to connect the 2 backbone cables? Is it one of the following AO6045, AO6075, AO6076 or AO6046 dependent on length and gender of the end connectors?
3) I assume that the Raymarine backbone will not require a 12 volt feed as the B&G backbone is already powered. Is this correct?
4) Anything else that I need to be aware of?
Bob Hickson
C&C 29 mk 2
bobhickson@rogers.com