Looking for i70 Wind system
I am looking for a wind instrument system. Within the last few years I have installed an e7D, depth transducer, speed & temp transducer, and an EV-200. I would now like to install a wind...
View ArticleChanging ip address on es98
just purchased an es98. Tried to connect to marina wifi and error message comes up that there is a conflict with ip address and to change the marina address. That is obviously not going to happen. I...
View ArticleCOG/SOG filter unavailable
I have a E97 MFD with external GPS150 from Digital Yacht connected to NMEA port 1 at 38400 Bauds. Sentences send by GPS are : GGA/GLL/RMC/GSV/GSA/VTG/ZD at 1 Hz rate. Internal GPS is disabled. GPS...
View Articleautopilot will not calibrate
Hello, I own a Raymarine autopilot (S1 computer and ST6001 controller). The autopilot worked flawlessly last year. I noted early this year that the fluxgate compass reading was about about 180 degrees...
View Articlea98 not responding to screen touches
I have a new (year old) a98 MFD that was working fine then all of a sudden, no touch. Tried power cycling and factory restarting. Is there anything else I can try?
View ArticleRD424 modulator board replacement
I have a 2006 4 kw analog radome (SN AE52067) that stopped working. I believe the problem is a blown diode, but don't know how to confirm that, or which one it might be. The sticker on the modulator...
View ArticleC80 broken a radar pin connector
My C80 has broken a radar pin connector. I'm outside the United States. I opened the C80 and I have in my hands the circuit board has connectors. The pins are soldered to the circuit board and is very...
View ArticleLinear Drive type 2 spare parts
Hi, hows does one go about obtaining spare parts for the linear drive unit? I would like to have spares of the plastic gears that I hear wear out. thanks bill
View ArticleOpen array selection
Will the new open array radars work with E Wide MFD? Also, will it overlay in chart mode? Thanks, Jack
View ArticleInstalling evo400 on a steel hull sailboat
Is there an issue install the evo400 system on a steel hull sail boat. What type of consideration for mounting the evolution compass?
View ArticleEV-1 "No Pilot" (SeaTalk connected but not Receiving)
This is a new installation of an EV -1 wheel pilot with P70 control head. It worked successfully for a week. Then the P70 would not light up. Raymarine sent me new P70. New p70 lights up, but I cannot...
View Articlesetup Ais 350
Dear Forum Members, I'm Trying setup my AIS 350, and it takes all the time detecting the model type and never read the AIS, displays that it is connected to the computer, but don't load the AIs. Could...
View ArticleA shout- out for Chuck
I have been using this Forum and the old Ray forum for a couple of years now and just want to say thanks Chuck for a job well done. And can you come and install my next set of electronics LOL
View ArticleAIS 350 ProAis2
Dear Board Members, I'm trying to put my MMSI, boat name and Etc, and the software doesn't allows me. Could I missing something? Do I need other soft to write? I Live in Brazil and here there is no...
View ArticleRadomes and Open Array Radar for retired MFD's w/Ethernet interface(s)
With the exception of Quantum radomes, all currently offered radomes (RD418D, RD424D, RD418HD, RD424HD) and open array pedestal radar systems (4/12kW HD Open Array Pedestals and 4/12kW Super HD Open...
View ArticleFinishing the install
I have installed CPT 120, DST 800, Wind Vane #E22079. All three need to be connected to something. I have a Seatalk NG starter kit not laid out yet. I have a A98 for the aft cockpit of my Irwin Mk II...
View ArticleClik here to view.
Mechanical Linear Drive exploded diagram / parts list
Please see the exploded diagram for the Raymarine Type 1 / 2 Linear Drives below. The attached PDF file includes part numbers (move cursor over notes within drawing). CRAFAQ# Linear Drive Exploded...
View ArticleClik here to view.
Autopilot Communication Issues
Hello, I have a customer who had his wind and depth instruments overhauled a few months ago. He replaced his old Sea Talk 1 system with I60 and I50 instruments and associated transducers. We have...
View ArticleClik here to view.
Autopilot
ST7001, the rudder indicator sometimes jumps and indicates a hard turn starboard or port and sometimes it seems to read correctly. I found a splice connection that had 3 colored wire connections and 1...
View Article