SR50 Weather/Audio problems with C80
Hello, I have subscribed to Sirius wx and audio..I am using the SR50 with the C80 mfd. I can received the audio channels but I am not receiving all of the subscribed channels. I have had Sirius rehit...
View ArticleReplacing s2 with ev-200
I have 2 e80 displays, DSM300 and HD Radome (connected to HS switch). I have a Remote, 2 Depth units (40 maybe?) and one ST6000 AP heaad. GPS was replaced by prior owner and I have no idea where it is...
View ArticleWhat type of fluid is recommended for use with my autopilot's hydraulic pump
Raymarine has made no recommendations regarding the specifications of the hydraulic fluid which should be used with its autopilot hydraulic drive units. Instead, Raymarine recommends that that the...
View ArticleIssues with ST70 AP
I recently bought a 2010 powerboat with a Raymarine package that in general is very nice. I have noticed two problems however with the AP ever since I took possession. 1. When using the track function,...
View ArticleC97 Unicontrol knob erratic behavior
Hello, I have a C97 MFD and the Unicontrol knobs behavior is erratic, when you turn the knob left or right to adjust settings it jumps all over the place. For example, if i turn it to the left to...
View ArticleE120 and Seatalk NG Alarm
I have a E120 (Classic) MFD interfaced to a Maretron Engine monitoring system (EMS100) using NMEA 2000/ SeaTalkNG. The E120 has SW Version 5.69. At low engine speeds while in gear, I get occasional...
View Articlest60+ tridata
A neighbor in the mooring field got hit by lightning. After turning on my instruments I found the depth is the only thing not working. I just have three dashes showing. How can I diagnose this problem,...
View ArticleLocating the EV Sensor
Hello - I have read some conflicting advice about locating the EV Sensor on a sailboat. Does it matter if the unit is placed forward or aft of the keel? Thanks for your advice, Martin Raphael
View ArticleDepth instrument reporting -.- at all times
In order for a depth instrument to report depth, the boat must be located in water and the depth of the water below the transducer must be at least 3' deep. Should this condition be met, then the root...
View ArticleClik here to view.
Mercruiser to E80 Classic wiring?
I am attempting to add digital read out of my two Merc 2007 496 Mag engines. I have a 2007 Formula 34 PC with dual Mercs. I'd like to read RPM, Fuel Flow, etc at my E80 Classic display. Attached are...
View ArticleI Want to up Grade, not sure what to do.
I currently have a c90w Display And most of the time my zoom out and in button will not zoom in. My question is I have the following electronics in my boat B60 XDUCER 20DEG TILT,DSM30 DIGITAL ECHO...
View ArticleTransducer for L470
I am looking for a replacement transducer for my L470 (Depth, speed, temp). Is there one available and do I need an adapter cable? -Jon
View ArticleGRIB files from phone to es98 MFD
Hi, Currently subscribed to PocketGrib via android phone. I download the GRIB files with the app to my phone microSD card. Have an es98 MFD with V17. Questions: Once the GRIB files are downloaded via...
View Articlei70 not showing speed
I have finally installed the network and instrument. Went through the set up process on the i70 and all seemed fine. But it is not reporting speed. In fact, there are no numerals at all shown for...
View ArticleUpgrade Compatibility From E-Serie Classic
I am thinking of upgrading the MFD on my 2007 Carver 41CMY. The engines are twin d6-370 Volvo diesels with EVC displays at the helm. (single helm) All electronics are original when purchased new so...
View ArticleRoute Following intermediate waypoint with e7
Hello, Are the instructions below still valid? To follow a route from an intermediate waypoint point of the route, 1. command the Chart application to follow the desired route or reverse and follow the...
View ArticleE120 Classic MFD with DSM300
The DSM has been working with the E120 for around 5 yrs - never a problem. This summer, I can't get the dsm info to the databar in the Navigation mode. Where the DSM info used to appear on the databar...
View Articlesea talk connection questions
Hi I am installing a Raymarine AIS 650 to an existing existing E125 sea talk network. What component will I need to connect the AIS to the sea talk back bone. Also can I get the gps data for my ICOM...
View ArticleClik here to view.
Time/Date jumping around
I just updated my Data Master e7 from 9.4 to the current Lighthouse. Had problems getting the SeaTalk NG to Seatalk converters to update, but finally got all the system updated, including the AIS 650...
View ArticleInterchangeability of Clearpulse and Downvision transducers
Have existing a67 MFDs (600W Sonar variant) driving E66088 (B60 12deg) hull mounted transducers. Can a a78 MFD (Downvision variant) be connected directly to the B60? even if there are limitations on...
View Article