Command Link interface
I have a set of 2007 F250 Yamaha outboards with Command Link, and I'd like to have the data available to be reported on my AXIOM MFD. I have a Yamaha Bus bar under the helm, and I have a H-5 network...
View ArticleClik here to view.
Interfacing differential NMEA 0183 devices to single ended NMEA 0183 devices
Interfacing differential NMEA 0183 devices to single ended NMEA 0183 devices While most marine electronics products having a NMEA 0183 communications interface feature a standard differential NMEA 0183...
View ArticleConnecting an ST1000+ to a Garmin
I have the ST100+ Autopilot, and a Garmin 942SX. I understand that it is possible to connect these two, but am finding the documentation challenging. The ST1000+ shows an NMEA + and - while the Garmin...
View ArticleClik here to view.
Rubber Boot for Switch on Raymarine Radar Pedestal
I have a 4kw Raymarine open array pedestal unit and I am looking for a replacement rubber boot to protect the On/Off switch on the back of the unit. The product code for the unit is: M92654-S and the...
View Articlees127 shuts down
When under sail for a few hours my new es127 shuts itself down. I can turn it back on, but after several minutes it does it again. After doing some research and talking with a Raymarine tech it appears...
View ArticleClik here to view.
Masthead Base Locking Ring Replacement
I have a newer style ST60 MH transducer and the mountbase twist locking ring has cracked and I would like to replace it. I was able to find the replacement part but not 100% sure how to install new...
View Articlee125 or c125
Hello can you help me in the selection of which MFD to purchase. What are the advantages of an E series vs a C series MFD? Assume the use is a 45 ft sailboat with a Ray260, Ray RD424HD, AIS 650 and...
View ArticleRAY 260 Speaker
I am installing a Ray260 and would like to understand what to order to have a remote mic and speaker in the cockpit of my sailboat. I am thinking the active speaker is better mounted in the cockpit and...
View ArticleAxiom/RV-100 installation
I have installed my new Axiom 9 RV and RV-100. I have recently received the Y-cable to connect my existing B-60 transducer. I have a few questions before finalizing the installation. Due to transom...
View ArticleCam210IP Reverse Image Lost
I updated my MFD's to the 19.03 release in order to take advantage of the Navionics Point to Point navigation. In so doing the Reverse Setting on the Cam210IP has been updated back to the original...
View ArticleClik here to view.
Problem reading deep water 400+
I have a had problems reading deep water with my electronics systems. I had a DSM 300 and now have a new CP370 and I am unable to see deeper than 400 feet. It reads strong bottom up to that depth then...
View ArticleWind Vane
I have a new masttop windvane that feeds a new i70 display (as well as a new MFD es98 on the network). It worked fine for a few weeks, but now suddenly only displays the wind speed... the yellow...
View ArticleeS78 MFD Doc to Doc Routing-not working sonar fish finder needs help too
I have an eS78, upgraded two weeks ago, renewed navionics for another year, retried auto routing or doc to doc but it still takes me over land and uses direct route. I tried using to shortest distance...
View ArticleNMEA Multiplexer?
My boat has a Raymarine 0183 multiplexer installed on it. Can I use a NMEA0183 to USB cable (for example, from Digital Yatch), and connect it into the multiplexer, to send routes to my G120/GPM400,...
View ArticleAxiom/ RealVision
I have a customer with an Axiom 12RV and a RV-21 thru hull. The whole system works fine except the display does not see the transducer, the screen just says no transducer present. Our installer hooked...
View ArticleCan a DF 7 Pro transducer CPT-DVS be used as a thru hull
I just purchased a DF 7 Pro yesterday after a TON of research on the unit itself......but really didnt pay attention to the transducer.......NOT GOOD I am also a member of various Yamaha Forums...
View ArticleDock to Dock Autorouting is producing a two point route over land
Dock to Dock Autorouting is producing a two point route over land Please click here to view a related FAQ. Should the items specified within the referenced FAQ have been addressed within your system,...
View ArticleUploading waypoints to legacy C80
I have a series of 250 waypoints i would like to load into a legacy C80 mfd. I have them as a KMZ file. If I load them onto a CF card will my C-80 read the file? I do have the latest software upgrade...
View ArticleClik here to view.
Problems with Axiom 12
Dear Members, After install Axiom 12 and put the Navionics plus card, something wrong happens in the screen and the MFD is not Running. Please see the photo attached. How can I solve this problem? Best...
View Article