I hooked up my new i70S instrument this weekend with the boat now in the water. During the initial setup (dockside with no water movement past the boat), the i70s detected my iTC-5 depth signal just fine but the speed/temp was greyed-out on the display. I opened the iTC-5 panel and saw a continuous light on the depth connection but blinking green lights on the speed/temp (as well as both rudder and wind which currently have no transducers).
Last season I was getting a signal from the speed/temp transducer just fine. Do I need to be under power or under sail during the initial setup for it to be recognized? I would think that even if I'm not getting a signal from the speed because we're dockside I would at least be getting temp.
I'm using an Airmar through-hull speed/temp transducer (probably 10-12 years old).
Last season I was getting a signal from the speed/temp transducer just fine. Do I need to be under power or under sail during the initial setup for it to be recognized? I would think that even if I'm not getting a signal from the speed because we're dockside I would at least be getting temp.
I'm using an Airmar through-hull speed/temp transducer (probably 10-12 years old).