Having problems getting a dst800 to seat in the thru hull with valve included with the transducer.
I am using yellow o-ring but transducer is very difficult to tighten and will not seat to the bottom of the thru hull. It appears to be about 1/4 to 3/8" from seating flush with the external surface of the thru hull.
Is there some trick to seating the yellow o-ring in the insert that would fix this?
![.jpg]()
IMG_4170 (2).jpg (Size: 64.83 KB / Downloads: 2)
I am using yellow o-ring but transducer is very difficult to tighten and will not seat to the bottom of the thru hull. It appears to be about 1/4 to 3/8" from seating flush with the external surface of the thru hull.
Is there some trick to seating the yellow o-ring in the insert that would fix this?
IMG_4170 (2).jpg (Size: 64.83 KB / Downloads: 2)