I have successfully installed all of my new electronics following the lightening strike as shown in the attached diagram. I now want to incorporate the analog signal from my engine temperature gauge and oil pressure sensor. I plan on purchasing an Actisense EMU-1 unit to do this. I am not sure how to connect the NMEA2000 output from this unit to my system. Would appreciate knowing what cables I will need and where in my system I can connect.
Randy
![.pdf]()
layout as installed.pdf (Size: 422.26 KB / Downloads: 1)
Randy
layout as installed.pdf (Size: 422.26 KB / Downloads: 1)