[CA11] Axiom 12 and Axiom 9 not communicating
I have an Axiom 12 Pro and Axiom 9 (display only). Before the last update (week ago) on both units, all was fine. The 12 was set up as the data master prior to update. Now the 9 does not acknowledge...
View Article[CA11] MFD Stylus Pen
My fat fingers have a hard time selecting points on the chart. Does anyone know of a stylus pen that will work on the e125 MFD? I have tried several with no luck. Steve
View ArticleAxiom units chane from ft/miles to m/km
Hi have Axiom 12 and have units set up as ft,nautical miles ,temp F have noticed on say 30 % of my trips that the units change to metric on there own . I then go back to settings and change them back....
View Article[TG11] Upgrade E Series Classic Slave
I have an E120 with an E80 slave at the helm. GPS, compass, radar etc. go to the E120. The card reader on the E120 is broken, so the chart card is in the E80. I have had no problems with the system,...
View Article[CA11] No Wind Vane Mode on Evolution Autopilot
I recently purchased a Catalina 315 with Raymarine instrumentation. Although wind information is available on the network and also the MFD can control the Autopilot, wind vane mode is unavailable....
View Article[CA11] New to Raymarine Products
I'm thinking of buying the Raymarine Axiom 7 but am not sure of which unit to buy. I know I want it to have RealVision 3D, but i'm not sure if I need one of the "charts" listed on the homepage. The...
View Article[CA11] E80 Not Displaying Charts
Hi, My E80 stopped displaying complete charts and now only displays the basic world chart. I pulled the chip and reinserted as well as restarting the unit but no luck. Any suggestions for how to...
View Article[CA11] AIS700 VSWR Fault
New installed Raymarine Axiom XL System on Yellowfin 36. Install was performed with help from Raymarine field rep. Getting external AIS, VSWR fault. Receiving data ok, transmitting is spotty. Seems to...
View Article[CA11] Enter waypoint by bluetooth
I have a new tacktick system. Can I enter waypoints from my iPad using iNavX?
View Article[CA11] C-80 COG after Factory reset
I accidentally did a factory reset on m Classic C-80. I have been able to get every thing set back up the way I had it previously to the reset except that it is not displaying a Course Over Ground now....
View Article[CA11] How to change backlight setting on ST7001+
My boat has an ST7001+ control head for the SPX30 autopilot. To change the back light level the manual says to press and hold the "Disp" button for 2 seconds, but all this does is change the page. I'd...
View Article[CA11] Auto Pilot pump conundrum
I may have an issue on hand. I have a 1994 Carver 390CPMY that had a RAYPILOT 650 installed with a type 1 pump. I bought the EV200 by the size of the pump that was on the bot lady installed. I recently...
View Article[CA11] Replacing C80 with Axiom 7
I am replacing my C80 with an Axiom 7. The C80 has the three wire hook-up (red, yellow, unshielded) for the network to my st60+'s. The Axiom has a pin plug. Is there an adapter for an easy replacement...
View ArticleSounder performance - background and diagnosis
WORK-IN-PROGRESS Introduction We are often asked why a fishfinder/sounder/sonar might be producing a poor-quality image, or not achieving the depth performance that the owner expects. It might be that...
View Article[DG11] C80 - no depth on chartploter but does show on fishfinder
Weird problem. Performed an update and also set the unit back to factory default. I didn't notice this problem immediately because I usually use the Lowrance 3500 mounted right in front of me but...
View Article[CA11] Smartcontroller compatibility
Is the Raymarine Smartcontroller compatible with Axiom RV and Axiom Pro RVX MFD's and an EV-400 autopilot?
View Article[CA11] AR200
Can the AR200 be used in lieu of a RS150 and EV1 to provide position and fast heading information in a LH2 (v19.03) system?
View Article[CA11] how to hide waypoints linked to a route
Hi I recently have an axiom 9, with sw version 3.10.42. When I hide a route, the waypoints associated with it, are still visible on the screen, and this cause confusion when I recall another route with...
View Article[CA11] waypoint names too long
Hi I have an axiom 9 with 3.10.42 sw version. When I want to display on screen thye waypoint names, I get too long names which cover other details on the screen, like i.e. "waypoint 241". There is any...
View Article