[CA11] Replacement of S1G with a Evolution
I have broken this post out of a previous thread I had (Raymarine forum / Raymarine Forums / Multifunction Displays / [CA11] Upgrades to my 2006 Four Winns ) because it only deals with the autopilot,...
View Article[LW11] Changing measurements on Wind and Speed guages
I have read the manual and still can't work out how to change the measurement setting on my gauges. I want to set my depth to metres my wind speed to knots and my SOG to knots. It has to be an easy...
View Article[DG11] No SOG
No SOG displayed after start up I have a ST60+ system with some additions ST60 Wind speed & direction (2002) (new masthead transducer installed 2014) ST60 Close hauled (2002) ST60 Tri-data (2002)...
View Article[DG11] How do I replace a ST60 Wind with a ST60+ CH Wind display ?
The ST60 Wind display packed up recently and the Raymarine agent local to the boat at the time reckoned it was not worth repairing. I searched online and found a ST60+ wind instrument for sale which...
View Article[LW11] A75 lighthouse 2 to 3 update
Hi guys, quick question. I have an a75 mfd running lighthouse 2, can i update this to lighthouse 3 and if so would it be wise to do so or would it have the same efect as updating from windows 7 to...
View Article[DG11] No Speed over Ground
No SOG displayed after start up I have a ST60+ system with some additions ST60 Wind speed & direction (2002) (new masthead transducer installed 2014) ST60 Close hauled (2002) ST60 Tri-data (2002)...
View Article[CA11] MFD a65 and aux
I have a A65 plotter (the classic one) and it has AUX port but I'm not able to find any documentation about it. What is it? And specially is it capable to work as a VGA input? If so what is the pin...
View Article[CA11] Axiom 9 Sounder issues
I am having issues with my sounder losing bottom and acting very strange. It isn't bubble related because it does is at all speeds and didn't do it when first installed. I have done everything...
View Article[CA11] New installation multiple power inputs
I have searched the forums and could not find a ready answer, so please forgive me if this is old news. I recently had a Raymarine dealer install a new Evolution autopilot system, a p70 control head, a...
View Article[CA11] Connect E7d to A75
Hi there, I’ve got an E7d at my main helm position and am considering getting an A75 to go on the fly bridge. On the E7d, I’ve got depth, radar, AIS and charts. What would be the easiest way to connect...
View Article[CA11] can LH3 support third party IP camera that is higher than 1080P now?
can LH3 now support third party IP camera that is higher than 1080P now? I have a Axiom MFD would like to buy a 4K camera to connect to Axiom. > - Network/IP Cameras (ex. Raymarine CAM210, CAM220,...
View Article[CA11] Adding refurbished eS98 to existing eS127 network
Hi Raymarine, Please see attached my current marine network wiring for both SeaTalk 1 / SeaTalk NG /NMEA 2000 setup (page 1) as well as current NMEA0198 wiring (page 2). I am looking at a refurbished...
View Article[CA11] Choosing the correct MFD
Hello, OK here it is, I am very confused on product selection, I have a 32' center console powered by twin Yamaha's, I have a pair of C120's and am wanting to upgrade to axiom 12 and a new autopilot,...
View Article[CA11] replacing C80 with two E80's Seatalk connection
IF the E80 at the helm is connected to all the seatalk instruments (through spliced seatalk 3 wire cable - from the C80 wiring), can I direct connect the nav station E80 to the Helm E80 with the high...
View Article[CA11] I70 Fuel Sensor
I just purchased the I70 Display. I have a Moeller Marine Electrical Reed Switch Fuel Sending Unit on my tank. What NMEA sensor would you recommend to connect the i70 to the sending unit?
View Article[CA11] "Current Limit" st6002
Hi, I have an st6002, spX10, running a type 1 drive unit, via sprocket & chain on a Lightwave 38 Catamaran These components have done around 2000 nm. Last time I went engage it, the screen showed...
View ArticleAutopilot control head reports Current Limit
Autopilot control head reports Current Limit The reported message is indicating that the autopilot course computer is sensing too much current draw from the drive unit. Causes for this condition may...
View Article[CA11] Raymarine axiom 9 rv
What’s up everyone? So I have a axiom 9 rv with the rv transducer on the boat, i also just bought the quantum radar and I’m looking to purchase another axiom but I would like to know if it’s possible...
View Article[CA11] upgrading E120
Need help with upgrade from E120/DSM300/B744 to Axiom Pro 12. I will be keeping my S3G course computer and ST8002 autopilot head. My deadrise is about 12 degrees. Currently, I have 2x 2" round...
View Article[CA11] Auto Pilot pump location
I have a 27 Boston Whaler with twin Mercury Verado's. I want to install the EV-200 and know that the A18127 hose kit is recommended. Given the extreme close quarters under the helm of the BW, the pump...
View Article