[DG] Rudder sensor with ACU-300
Dear all I have read in ACU-300 manual that the rudder sensor connection is recommended, but not mandatory. In appendix B of the manual I have read also that the message number 127245 "Rudder Angle" is...
View Article[CA11] Control "my boat" icon size, LH3
Hi--Is there a way in LightHouse 3.6 to reduce the "my boat" icon size? Thanks. --Mark
View Article[CA11] E7D stopped receiving data through my ECI-100
Hello, Recently I stopped receiving engine data to my E7D a few weeks ago? The ECI-100 SeaTalk LED light blinks green every 15 seconds and the Engine CAN bus LED light blinks red 7 times and then stops...
View Article[CA11] Mechanical Linear drive
I have a St4000 MK2 Wheel pilot. I was wondering if I could connect a Type 1 Mechanical Linear Drive to my ST4000 Corepack computer to replace the wheel drive unit.
View Article[CA11] ST60+ TWS from GPS
I have a ST60+ Wind, ST60+ Tridata with DST800V Triducer and an ST60+ Graphic Display, all inter-connected via Seatalk cables. I recently purchased a Standard Horizon GX1700 VHS radio with built-in...
View Article[CA11] S100 does not beep
Just bought a new S100 Controller for my C-80. Previous one failed. The new one does not beep when you push the buttons, especially unpleasant during course changes. My old one did. It is a nice...
View Article[CA11] Low voltage to itc5 for wind speed
Put a new itc5 in. The itc5 only had 2.4v across wind terminals. Same on compass. Checked the feed wire coming to itc5 which only had 8.4v. Jumped 12v from a lug to wind red wire. Wind started working....
View Article[CA11] c95 to existing ST1 daisy chain
I have a loop of existing ST1 chain entering and exiting my pedestal connecting an ST80 Masterview and ST80 AP keypad... I thought that connecting a c95 was going be a simple plug and play with a...
View ArticleClik here to view.
[CA11] Water Temperature Conflict
Hi - I'm hoping that you might be able to guide me in resolving a water temperature conflict on my Raymarine setup. My setup is as follows: - e127 MFD is the data master, connected to the NMEA2k...
View Article[CA11] Linear Drive Maintenance
Hi, I have a Raymarine mechanical linear drive. I just completed a 5000 mile passage and was reviewing the linear drive manual for periodic maintanence requirements. The manual say the unit should be...
View Article[CA11] RP650 remote options
I have an older Raytheon RP650 head on a 400 course computer. What are my options to add a remote? I realize said remote might not be available new anymore, but I will look on eBay and other forums....
View Article[CA11] Autopilot alert - Rudder position info lost
Jeanneau 349 sailboat 2017. In Toronto. ACU 400 autopilot lost rudder info while sailing with Autopilot on standby. Alert appears on a75 mfd and rudder position bar is still there but does not show...
View Article[CA11] E80 MFD NEMA
I have inherited a E80 MFD and a RD424 Radome which I plan to put on my boat. I also have a Garmin Echomap Chart Plotter which I use for navigation. To have a little redundancy, I'd like to use NEMA to...
View Article[CA11] Axiom 7 satellite acquisition
How long should my Axiom 7 take to acquire satellite data? Currently it seems to take 20-30 minutes, I'm sure it used to be quicker with LH2, now on LH3.4 qnd have downloaded 3.6 in the vain hope that...
View Article[CA11] SPX-10 replacement
I have a cruiser with the spx-10 autopilot installed. I have a fluxgate fault and the fluxgate ohms checks good. The auto pilot will not turn off and displays a constant fault on the c-series 125...
View Article[CA11] C80 Classic
What does the “Chart View” “Local” vs “System” mean/change on the C80 Classic? I cannot find a reference to this function in the Owners manual.
View Article[CA11] ST 5000+ autopilot issues
The autopilot on my flybridge trawler has been steering the vessel in slow ~30° S-curves to port and then to starboard when placed in "auto" mode. The vessel will maintain the average magnetic heading...
View ArticleClik here to view.
[CA11] E7D Display vs RayView
I started having a problem with my E7D display out of the blue. It has been working great for a along time and now the colors are separated making it very difficult to read. When I access the MFD via...
View Article[CA11] Integrating VHF and AIS to Classic E MFDs
We have E120 at the helm and E80 down below, connected via Ethernet hs. We recently installed an AIS, which is integrated via NMEA 0183 to the E80. This required us to disconnect the VHF radio NMEA...
View Article[CA11] Networking Question
I have an Axiom 12 on my boat (2018 Monterey 335 Sport Yacht) and am trying to learn more about the system for future expansion. Right now I have the normal sonar (not 3d) and also have the 260 VHF. I...
View Article