[CA11] Axiom and e97 on network
I have a new Axiom 9 that has been installed on my network which is a Seatalkng and using a hs5 network network switch. On the seatalkng network I have a e97, ACU200 and EV1, P70R and a i70. On the hs5...
View Article[CA11] AIS 700 VSWR Fault
I have been helping a friend with a partial upgrade to the electronics on a new to him 2006 Albemarle 280. We have installed an Axiom Pro 9 with a pair of through hull RV transducers. Although we...
View ArticleRaypilot 650 Control Head
Installed a Vulcan 7FS plotter....have a Raypilot 650 control head (seatalk) connected to a Yacht Devices seatalk-0183 converter, then to an Actisense NGW-1 0183 to 2000 converter....goes into network...
View Article[CA11] ST60 Wind instrument with E22158 ?
Hi Forum. Have a NMEA2000 wind instrument. Will the E22158 convert NMEA2000 wind data to appropriate SeaTalk wind sentence to display on ST60 ? I've used ST60 wind instruments as repeaters for other...
View ArticleCannot enable LightHouse 3 Autopilot Controls feature with legacy autopilot
Cannot enable LightHouse 3 Autopilot Controls feature with legacy autopilot The Autopilot Controls feature of LightHouse 3 software is restricted to systems featuring Evolution autopilots. While this...
View ArticleClik here to view.
[CA11] Ray50 software update kills the device
Hello. This week I updated the software of all the equipment on my boat. Everything went very smoothly until the software update of my VHF ray50 radio. After the update, the device turns on but...
View Article[CA11] Evolution - "No drive detected" "No pilot"
I have a three year old Evolution 200 system with ACU200/EV1/P70/Axioms running a Type 1 Linear Drive. I recently updated the Axiom software to get my Sirius up and running. I am getting intermittent...
View Article[CA11] Axiom 9 questions
I have 2 units networked but I can’t seem to get the forward transducer to show on bow unit. When I go to select transducer, the only option is the 3dr transducer which is on the transom. I have a...
View ArticleRaymarine 400G and Lighthouse 3
Is the 400 or 400G autopilot computer with the ST600R control unit designed to work with Lighthouse 3? I have the converter installed and passing data but am not able to enable auto pilot slider in the...
View Article[CA11] Water Temperature Source
I do not see a way to select water temperature source in Lighthouse 3. Am I missing something? I have older ST60 tridata that has taken over as the data source for water temperature. This temperature...
View Article[CA11] replace C80-help
I have a 2006 c80 Classic with a DSM 300 module, Rs232 (I have no idea what this does) and GPS. The gps also sends position data to my raymarine VHF. The boat is a small 22' center console so don't...
View Article[CA11] Refurbished Warranty
If I register a refurbished product do I get a 3 year warranty or only 2?
View Article[CA11] the right auto pilot
Hello I Have the C80 Display with the Ray Nav 300 Plotter with the Radome I Have A 2002 36 foot Sea Ray I Am looking for some advice witch auto pilot would be right for my system and witch pump would...
View Article[CA11] ST8001
I have an ST8001 linked in through Sea Talk. When I turn the knob to change direction a few degrees, it will jump 10-15 degrees and sometimes go in the opposite direction. Can these be repaired or is...
View Article[CA11] Accessing Wind Vane Mode from Axiom MFD
Hello... I cannot seem to figure out how to access Wind Vane mode for the EV-100 Auto Pilot from the Axiom 7 MFD. I am running all current updates. I have tried to find the information in the faqs and...
View ArticleTilt data box on i70s
I have an EV-1 and an i70s on the network and according to the docs and other posts on this forum I should be able to display “tilt” information, which is the heel angle of the boat. However, the i70s...
View Article[CA11] Installing Two Remote Card Readers
In order to run two charts are simultaneously, I plan to replace the RCR-SD/USB-Card Reader (A80440) that is connected to my Axiom 12 with an RCR-2 Remote Card Reader (A80218). I also have an Axiom 9...
View Article[CA11] Auto pilot
I will soon be having an Auto pilot installed on my boat .. The Dealer will be doing it and I would prefer to stay with all Raymarine. My MFD is an e127. The boat is a 30 foot Grady White marlin with...
View Article[CA11] ST60 wind vane issue
Hello, I have a faulty ST60 wind transducer. I took it apart and powered the PCB with a lab power (8V between red and screen wires). When probing directional signals (blue & green) with an...
View Article