(DG) T120 replacement set up
I have a replacement T120 wind transmitter for use with a Tacktick MN100 display. Looking for instructions on how to sync the new masthead device. Any help or setup document is appreciated. Thank you
View Article(DG) E80 Seatalk2 output to ST60+
Just replaced my C80 with an E80 connected to a DSM 300 via SeaTalk HS. Trying to sort out how to connect my ST60+ (Depth) and assumed I could use the Seatalk 2 output on the back of the e80. Figured...
View Article[CA] SPX30 Doing Poorly in Track Mode
I have an SPX30 (V3.05 software) connected to a P70 (V3.07). A non-Raymarine chartplotter is connected providing navigation information over NMEA. The AP works flawlessly in Auto mode and does a pretty...
View Article[CA] Es97 touch screen issues
I have two MFD, one at each helm. Both of them have begun to behave badly. The touch function deteriorates after about 20 minutes to the point that it no longer works. Soon after that, the screen...
View ArticleClik here to view.
[CA] AIS700 to Tacktick T122 and Actisense NGW-1
Hi, I have a brand new AIS700 transponder and I would like to connect it to my existing instruments, which are: - a Tacktick T122 Interface, - 2 Standard horizon VHF: 1600 Explorer and HX471S. - 1...
View ArticleClik here to view.
[CA] E120 Classic Bezel
I’m looking for a replacement bezel for an E120 Classic. My fly bridge unit’s cracked severely at 3 corners over the winter. (Weather sealed too tightly to the NaviPod?) If any one has a bezel, or a...
View ArticleClik here to view.
[CA] My i70 display will not show indicated SOG
Hi All I cannot figure out why my i70 display will only show indicated SOG on one screen and not on any other screens. It receives speed data from the GPS on the chart plotter. The auto pilot uses the...
View Article(DG) Quantum 2 cable length shortening
I've ordered a Quantum 2 radar and would like to know if it is ok to cut the radar cable and install connectors on it at the base of my mast. Does Raymarine have the connectors?
View ArticleCutting and joining communications cables
Raymarine always recommends using the correct length Raymarine supplied cables with pre fitted connectors and the range of T Pieces and connectors available specifically for this purpose. Whilst it is...
View ArticleInstallation and operations guides not packaged with Raymarine MFDs
Installation and operations guides not packaged with Raymarine MFDs Early marine electronics were manufactured with software which could only be installed by the manufacturer and as a result supported...
View Article(DG) Powering Backbone
Hello, I have a question about power on my backbone. I have : 1 x Axiom Pro 7" (has its own direct to bus power) 1 x EV400 + Sensor Core and RAT - All powered off EV400 - the switch to allow the EV400...
View ArticleClik here to view.
(DG) Autopilot interference on echosounder
Hi I´am experiencing serious interference from autopilot on my echosounder. All products are Raymarine. - Evolution autopilot w/ ACU200 - eS128 MFD with CP370 sonar module - Transducer is B260 The...
View Articlees127 touch screen issue after cleaning
The touch screen on my es127 MFD no longer functions. It was working OK before I cleaned it (with fresh water only), but had a substantial amount of salt on it from an ocean crossing. Now, I very...
View Article[CA] Dragonfly7
I have a Dragonfly 7 purchased in 2015. Questions: 1. How do I enter GPS numbers into my unit? 2. I don't get a depth reading when traveling more than an idle speed. Doesn't matter the speed. Is this...
View Article[CA] Lighthouse 3 Streaming App
With apps like Netflix included in the 3.4 release, it would seem relatively easy to offer streaming (or screen mirroring} from one's phone or tablet to an Axiom screen. Just a suggestion!
View Article[CA] Autopilot - HDG into wind
Would be nice to see a option to hold the boat into wind while hoisting sails. Might already be possible but I couldn't see the option. Cheers W
View Article[CA] es127 WiFi
Are WiFi updates ever going to be re-available on the es series MFDs for wireless software updates when running LH3? Thanks
View Article[CA] eS127 w/LH3 & no WiFi
Just updated my eS127 to LH3 and it seems I have lost my ability to connect my MFD to the internet. In reading the software update page it looks like that capability is not available for an eS MFD....
View Article[CA] e127 not recognizing radar
Boat is new to me as are the electronics.. The e127 has the latest update (19) ... it would not recognize the radar before or after the update. .. The radar has power to it ... I tried to "wake it up"...
View Article