[CA] Axiom 7 and i60 wind system
Hello, I just installed an Axiom 7 and i60 wind system on a sailboat. I built a Stng network using an E22158 (to integrate existing ST1 speed/depth). The i60 shows as a source of wind data in the Axiom...
View Article[CA] Axiom Pro Heading Data from Autopilot
Just completed installation of 2 new Axiom Pro MFDs, with i60/i50 + i70s instruments, iTC-5 for all the transducers. There is currently a Simrad J300x-40 autopilot installed in the boat. For whatever...
View Article[CA] C80 with DSM30 Connection Problems
I'm using a C80 with a DSM30 and P79 transducer. The C80 reports depth info for about 5 seconds and then stops and gives a no input error. After about 1 min it repeats this pattern. My C80 software is...
View Article(DG) ST60 Depth Transducer to i50 Depth Head
Hi, I have a 1994 Sailboat that came with the ST60 Depth/Speed. Head is sun washed and would like to replace it with the i50 depth. I read the specs of the i50 and it seems that it's compatible with...
View Article[CA] Relative vs True
I have a eS179. In Radar or AIS under the "Collision Avoidance" tab. Under "Target Vectors" you have the choice between "Relative" or "True." What are the definition of these two terms and their...
View Article(DG) DSM300
I currently have a C120W that has one of the Seatalk HS hooked to a radar and the other Seatalk HS is not being used. I recently purchased a DSM300. Is the preferred connection directly to the DSM...
View Article(DG) system upgrade
Replacing a C80 on a 40ft sailboat. currently have radar, ST60 speed & depth and wind. Autopilot is separate. The plan is to replace C80 with Axiom Pro 12 and Quantum radar while maintaining older...
View Article(DG) Difference between Down Vision and Conical Sonar
What are the differences between Down Vision and Conical Sonar for the Axiom Pro RVX? Thanks.
View ArticleConnecting C120W MFD to DSM300
When connecting a C120W to a DSM300, is a crossover coupler needed? The DSM300 can be connected direct to one of the STHS sockets on the C120W, no crossover cable is needed this link describes in...
View ArticleClik here to view.
Difference between Downvision and Conical Sonar
The difference can more easily be understood when looking at the difference in images generated by the two different technologies, The Downvision image is shown here as the copper tone (standard...
View ArticleWhen is a HybridTouch interface or RMK-9/10 recommended
When is a HybridTouch interface or RMK-9/10 recommended MFDs featuring touchscreen-only interfaces are an excellent choice for those who will not be using the MFD under environmental conditions where...
View ArticleWhen to use the Data Sources feature of a MFD, i70 MFID, or p70/p70R?
When to use the Data Sources feature of a MFD, i70 MFID, or p70/p70R Autopilot Control Head? While more than one source of any of the below listed items may be present within a SeaTalkng / NMEA 2000...
View Article[CA] cable end plugs
I have a c125 mfd mounted to my transom I remove the display when the boat is not being use, is there water proof cable plugs for the raynet and c125 mfd power cables when not connected to the display?
View ArticleProtecting power and comms cable plugs when removing equipment from boat
Protecting power and communications cable plugs when removing equipment from boat It is not uncommon for bracket mounted equipment to be removed from the vessel after each use or when a vessel is laid...
View Article(DG) Type 1 Pump
A friend is selling a newer EV 200 autopilot system Includes everything except the Type 1 pump Question: Can I source any Type 1 autopilot pump to fit this unit/system? Or must this be a specific...
View Article[CA] Instrument Settings via Network
I have a pair of Axiom Pros, a pair of P70s auto-pilot heads, and a couple of i70s units. Is there a way for common settings for the i70s to be retrieved from the SeaTalkng network? For example, I know...
View Article[CA] Fusion Compatibility
Is the new fusion MS-RA70Ni (NEMA2000 compatible) able to be controlled by a ES128?
View Article[CA] 50/200 as well as Chirp via a second Axiom?
I am currently running an AXiom 9 RV with a RV-100 transducer. Although I purchased the appropriate Y-cable to use my existing B60 transducer with this system, I ended up reinstalling my old DSX500I so...
View Article[CA] Cant get new es98 mfd and autopilot to turn on
Just bought a es98 mfd, type 1 hyd pump and ACU 200 controller and cannot get the mfd to even light up. Tried to follow directions very carefully but what am I doing wrong? Does the es98need the NEMA...
View Article[CA] Trouble Uploading Software Update to a98
I have an a98 currently running software v.14.36. I purchased a new SanDisc (mSD) with 8GB of storage. Went to the Raymarine website and downloaded v19.03 to the root file of the mSD card. The mSD card...
View Article