A recently upgraded system has two eS series MFD's, an RS130, ST1 to STNG converter, ST70, SPX 30 course computer, ST60 and Smart Pilot RF remote. eS series units are at v17.45, ST1 to STNG converter is at 2.01 and the SPX 30 was successfully updated from v1.18 to 3.05. However, when the software update is executed for the ST70, it does not update even though the the update indicates a v3.04 update and the ST70 is at version 1.06. See attached pictures. I have noticed that the product ID for the update is P625 while the product ID for the ST70 is D625. I'm not sure if this matters or not.
Any suggestions on how to get the ST70 updated? Could this be a bootloader issue? I see that in the version 2.05 and 3.03 the bootloader was updated from the current ST70 bootloader which is v.19.
![.jpg]()
IMG_1082 ST70 Attempted Update Part 1.JPG (Size: 74.52 KB / Downloads: 1)
![.jpg]()
IMG_1085 ST70 Attempted Update Part 2.JPG (Size: 86.19 KB / Downloads: 1)
Any suggestions on how to get the ST70 updated? Could this be a bootloader issue? I see that in the version 2.05 and 3.03 the bootloader was updated from the current ST70 bootloader which is v.19.
IMG_1082 ST70 Attempted Update Part 1.JPG (Size: 74.52 KB / Downloads: 1)
IMG_1085 ST70 Attempted Update Part 2.JPG (Size: 86.19 KB / Downloads: 1)