Hi,
Have an a75 unit that came with a boat I bought. Software was updated last week, and I'm running Navionics charts without issue. It was just a standalone chartplotter.
I wanted to add engine interface, so interfaced to the gateway, got the patch cable and the NMEA backbone all hooked up and powered up.
I went to the engine setup wizard on the unit, nothing found. Went to the settings to check for devices/external data, nothing found. I made sure it was the data master. Checked to see if there were any other settings available - didn't see anything else.
So, I pulled it next to my other boat, connected everything to my other boats network and e97, and instantly had all the data from the engine. Only thing I changed was unplugging the spur and running a longer backbone cable - I used the power source for the e97 on the Yellowfin and the network was powered by the RHIB.
So, what's wrong with my a75? Am I missing some kind of communication/network setting? Or is it a hardware issue?
Thanks!
Have an a75 unit that came with a boat I bought. Software was updated last week, and I'm running Navionics charts without issue. It was just a standalone chartplotter.
I wanted to add engine interface, so interfaced to the gateway, got the patch cable and the NMEA backbone all hooked up and powered up.
I went to the engine setup wizard on the unit, nothing found. Went to the settings to check for devices/external data, nothing found. I made sure it was the data master. Checked to see if there were any other settings available - didn't see anything else.
So, I pulled it next to my other boat, connected everything to my other boats network and e97, and instantly had all the data from the engine. Only thing I changed was unplugging the spur and running a longer backbone cable - I used the power source for the e97 on the Yellowfin and the network was powered by the RHIB.
So, what's wrong with my a75? Am I missing some kind of communication/network setting? Or is it a hardware issue?
Thanks!