I currently have an axiom 9 RV 3D with RV 100 transducer. The unit is networked to Ray 52 and EV100 autopilot. I am thinking of adding a second axiom 9 display (chart plotter only). Are there any extra advantages to doing this other than more screen space?
To connect these units If I purchased a Ray cable A62361, do I just update each unit to the most recent software, shut down, connect the cable and turn both units on? Next would I be prompted to select the RV as the “master”? Are these steps correct? Any other steps I would need to take? Would I need to put the included Navionics chart in the second unit as well? Do I need to do the set up wizard for the second unit, or will this change automatically once networked? Anything else I should know about adding the second axiom?
To connect these units If I purchased a Ray cable A62361, do I just update each unit to the most recent software, shut down, connect the cable and turn both units on? Next would I be prompted to select the RV as the “master”? Are these steps correct? Any other steps I would need to take? Would I need to put the included Navionics chart in the second unit as well? Do I need to do the set up wizard for the second unit, or will this change automatically once networked? Anything else I should know about adding the second axiom?