I'm troubleshooting my ST60 Wind unit's constant flashing of the True and Apparent lights.
Following the self test procedure I got "F01" in the first step of the test outlined in the manual. Next trip to the boat, I'll take a power source and multimeter to preform the test to confirm the masthead is transmitting and also consider a factory reset as a step to attempt to recover the functionality.
From reading previous forum inquiries/replies and explainations of true/apparent wind it appears that the "speed signal" is either not transmitting to the ST60 Wind unit or the supplied signal isn't being interpreted correctly. Do I understand correctly that this would be the reading of the "yellow" wire into the ST60 Wind unit?
Are there any additional suggestions or steps I should try outside of 1) a factory reset and 2) confirmation of correct voltages from sensors on the mast using the procedures supplied in the manuals?
Thanks in advance for any assistance or suggestions.
Todd L.
Following the self test procedure I got "F01" in the first step of the test outlined in the manual. Next trip to the boat, I'll take a power source and multimeter to preform the test to confirm the masthead is transmitting and also consider a factory reset as a step to attempt to recover the functionality.
From reading previous forum inquiries/replies and explainations of true/apparent wind it appears that the "speed signal" is either not transmitting to the ST60 Wind unit or the supplied signal isn't being interpreted correctly. Do I understand correctly that this would be the reading of the "yellow" wire into the ST60 Wind unit?
Are there any additional suggestions or steps I should try outside of 1) a factory reset and 2) confirmation of correct voltages from sensors on the mast using the procedures supplied in the manuals?
Thanks in advance for any assistance or suggestions.
Todd L.