RE: Mechanical Installation of drive unit
I recently had my ST 6000 unit reworked at Raymarine and am now re-installing it. Reviewing the manual I find it hard to believe but there are only installation instructions for the electrical connections and the control unit and absolutely nothing about the mechanical installation of the drive unit.
I have replaced the drive unit on the pivot rod and have extended the drive arm to its connection point on the rudder yoke. However, there is a loose nut just exiting the large part of the drive arm which looks like it should be tightened to the end of that part of the drive arm. However, what position should the arm be when that nut is tightened?
Your manual does not address this at all. Please help
I recently had my ST 6000 unit reworked at Raymarine and am now re-installing it. Reviewing the manual I find it hard to believe but there are only installation instructions for the electrical connections and the control unit and absolutely nothing about the mechanical installation of the drive unit.
I have replaced the drive unit on the pivot rod and have extended the drive arm to its connection point on the rudder yoke. However, there is a loose nut just exiting the large part of the drive arm which looks like it should be tightened to the end of that part of the drive arm. However, what position should the arm be when that nut is tightened?
Your manual does not address this at all. Please help