So I just purchased a T70133 kit to replace my failed RN300 system. I have a C80, radar, Auto pilot and st6001 controller and the Failed RN300 that I plan to do away with completely on a 22' C-Dory.
It looks simple enough to hook this up except for the fact that my system has neither a D244 junction block or a R55006 that is shown in the instructions diagram. Instead it has a generic marine terminal bus that the wires from all said components are screwed in to. There is not a dedicated power wire going in to the terminal so I must assume that power is being supplied from either the Auto pilot, C80 or RN300.
I am not sure of how to disconnect the current power input so that I can supply power through the SeaTalkng converter to the system. Any help with this would be greatly appreciated.
Thanks
Doug
It looks simple enough to hook this up except for the fact that my system has neither a D244 junction block or a R55006 that is shown in the instructions diagram. Instead it has a generic marine terminal bus that the wires from all said components are screwed in to. There is not a dedicated power wire going in to the terminal so I must assume that power is being supplied from either the Auto pilot, C80 or RN300.
I am not sure of how to disconnect the current power input so that I can supply power through the SeaTalkng converter to the system. Any help with this would be greatly appreciated.
Thanks
Doug