I am investigating installing the 210IP Camera into our current system. The system has a HS Network Switch with available RJ45 ports. MFD's are es127 and an eSeries.
Cable Run is about 30 ft.
1. Can I run shielded RJ45 male to Male cable from the HS Network Switch to the Camera?
2. Should I run 16 gauge Red/Black Power Cable?
3. Will the pigtail on the camera connect both the RJ45 and the Power Cable?
4. Should I have a separate power switch for the camera?
Any other recommendations would be appreciated.
Thank You
Barry
Cable Run is about 30 ft.
1. Can I run shielded RJ45 male to Male cable from the HS Network Switch to the Camera?
2. Should I run 16 gauge Red/Black Power Cable?
3. Will the pigtail on the camera connect both the RJ45 and the Power Cable?
4. Should I have a separate power switch for the camera?
Any other recommendations would be appreciated.
Thank You
Barry