Had to replace Radar radome and cable due to dismasting. New radome does not communicate with MFD.
Hardware: C90W ser# E621110500129, App. Vers. v2.35, Baseboard v3.05
Radome RD418D4kW, IC:4069B-18DD4kW. Radome connected directly to the MFD via reverse coupler (no switches etc.) and Ethernet cable. Radar cable tested for continuity - OK, power tested OK. Radome was tested OK in the shop BUT via network cable (not ethernet cable)
On diagnostic page Ethernet summary shows activity on all lines except "Received and Transmited TCP bytes" which shows 0 . External devices show "0" , Scanner page shows "Buffer"
Is there any way to do test via Ethernet and laptop ? I am located in Windward Islands - shipping of the hardware for test is pretty much out of question. Is there any possibility that during the dismasting some circuit fuse within the MFD tripped ? (The main breaker for the radar tripped during dismasting.)
Any help how to proceed with trouble shooting would be appreciated.
Thanks, Petr
Hardware: C90W ser# E621110500129, App. Vers. v2.35, Baseboard v3.05
Radome RD418D4kW, IC:4069B-18DD4kW. Radome connected directly to the MFD via reverse coupler (no switches etc.) and Ethernet cable. Radar cable tested for continuity - OK, power tested OK. Radome was tested OK in the shop BUT via network cable (not ethernet cable)
On diagnostic page Ethernet summary shows activity on all lines except "Received and Transmited TCP bytes" which shows 0 . External devices show "0" , Scanner page shows "Buffer"
Is there any way to do test via Ethernet and laptop ? I am located in Windward Islands - shipping of the hardware for test is pretty much out of question. Is there any possibility that during the dismasting some circuit fuse within the MFD tripped ? (The main breaker for the radar tripped during dismasting.)
Any help how to proceed with trouble shooting would be appreciated.
Thanks, Petr