When powering up my instruments my ST6000AP had blinking standby and auto buttons and a constant beeping. The display did not show anything. My setup is an A128 MFD connected to STNG and ST60 wind ST60 multi and ST6000AP (on S1 course computer).
This has been working flawlessly since I installed the A128 about 20 months ago. The troubleshooting guide shows nothing regarding the blinking. I assume since the buttons are blinking and there is a beep that the power is reaching the ST6000. The odd thing is, when I set a mark on the MFD and GOTO that mark the AP works as it should.
Any ideas?
This has been working flawlessly since I installed the A128 about 20 months ago. The troubleshooting guide shows nothing regarding the blinking. I assume since the buttons are blinking and there is a beep that the power is reaching the ST6000. The odd thing is, when I set a mark on the MFD and GOTO that mark the AP works as it should.
Any ideas?